Toshiba e-STUDIO556 Service Manual page 187

4.3.12 Lens unit (e-STUDIO556/656/756/856)
[A] Removal of the Lens unit
(1) Take off the lens cover.
( P.4-11 "4.3.2 Lens cover")
(2) Disconnect 1 connector, remove 4 screws,
then take off the lens unit.
Notes:
• When installing the lens unit, fix it while
pushing it to the rear direction.
• he lens unit must not be readjusted and
some part of its components must not be
replaced in the field since the unit is
precisely adjusted. If any of the
components is defective, replace the
whole unit.
Notes:
• Do not touch 8 screws shown with the
arrows when replacing the lens unit.
• Handle the unit with care. Do not touch
the adjusted area and lens. (Hold the unit
as the right figure.).
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Lens unit
Fig. 4-63
Fig. 4-64
Fig. 4-65
e-STUDIO556/656/756/856/557/657/757/857
4 - 23
DISASSEMBLY AND REPLACEMENT
4