Toshiba e-STUDIO556 Service Manual page 330

4.13.33 Original pickup solenoid (SOLR1)
(1) Take off the RADF rear cover.
( P.4-136 "4.13.3 RADF rear cover")
(2) Disconnect 1 connector.
(3) Remove 2 screws and take off the original
pickup solenoid.
(4) Remove 2 screws and take off the bracket
from the original pickup solenoid.
Note:
When installing the solenoid, check if it is
aligned with the position indicated in the
figure. (The scale is longer in the center.).
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 166
Fig. 4-469
Fig. 4-470
Fig. 4-471