Toshiba e-STUDIO556 Service Manual page 542

* 22. Discharge LED
Clean with soft pads or cloth. Do not use a vacuum cleaner.
* 23. Exit roller
Remove the pin from the exit roller (upper), and then apply a few drops of silicon oil over
the hole of the exit roller.
* 24. Exit roller drive gear
Apply 1 rice-grain amount of white grease (Molykote EM-30) on the shaft section where
the drive gear is installed.
* 25. Separation roller (bypass feed unit)
Apply an even coat of grease (Alvania No.2) to all round the inside of the spring.
* 26. Paper dust removal brush
Clean the frame if needed because paper dust brushed off with the corresponding brush
accumulates on the lower frame of the registration rollers.
(Cleaning period guideline: Every two or three times of Preventive Maintenance.)
e-STUDIO556/656/756/856/557/657/757/857
PREVENTIVE MAINTENANCE (PM)
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
7 - 32