Toshiba e-STUDIO556 Service Manual page 272

4.10.6 Horizontal transport sensor-1, -2 and -3 (S19, S20, S21)
(1) Take off the transfer unit.
( P.4-102 "4.10.1 Transfer unit")
(2) Take off the fuser unit.
( P.4-115 "4.11.2 Fuser unit")
(3) Remove 1 screw to take off each sensor with
its bracket.
(4) Disconnect 1 connector and release the latch
to take off each sensor.
Note:
The horizontal transport sensor-3 (S21) can
be replaced without the transport unit being
taken off.
4.10.7 Horizontal transport section driving clutch-2 (CLT2)/ -3 (CLT3)
(e-STUDIO556/656/756/856)
(1) Remove the transfer/transport unit.
( P.4-106 "4.10.5 Transfer/Transport unit")
(2) Disconnect 1 connector and remove 1 E-ring
to take off the each clutch.
4.10.8 Horizontal transport section driving clutch-2 (CLT2)/ -3 (CLT3)
(e-STUDIO557/657/757/857)
(1) Remove the transfer/transport unit.
( P.4-106 "4.10.5 Transfer/Transport unit")
(2) Disconnect each connector and remove 1
clip. Remove horizontal transport section
driving clutch-3 (CLT3) [1] and -2 (CLT2) [2].
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Horizontal transport
sensor-1
Screw
Horizontal transport
sensor-2
Horizontal transport section
E-ring
driving clutch-3
[1]
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 108
Horizontal transport
sensor-3
Screw
Fig. 4-302
Horizontal transport section
driving clutch-2
E-ring
Fig. 4-303
[2]
Fig. 4-304