Toshiba e-STUDIO556 Service Manual page 327

4.13.30 Original reverse motor (MR3)
(1) Take off the RADF rear cover.
( P.4-136 "4.13.3 RADF rear cover")
(2) Disconnect 1 connector.
(3) Remove 3 screws and take off the original
reverse motor with the bracket.
(4) Remove 2 screws and take off the bracket
from the original reverse motor.
4.13.31 Original exit motor (MR4)
(1) Take off the RADF rear cover.
( P.4-136 "4.13.3 RADF rear cover")
(2) Disconnect 1 connector [1].
(3) Remove 1 spring [2].
(4) Loosen 2 screws [3].
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-461
Fig. 4-462
Fig. 4-463
e-STUDIO556/656/756/856/557/657/757/857
4 - 163
Connector
[3]
[2]
[1]
[3]
DISASSEMBLY AND REPLACEMENT
4