Toshiba e-STUDIO556 Service Manual page 843

(7) If "4. License FROM to SRAM" is performed by mistake, carry out the following procedure.
 P.9-37 "[A] Re-registration when the board is replaced"
[G] Update firmware version
(1) Update the version of scanner firmware with the USB device.
 P.11-9 "11.2 Firmware Updating with USB Media"
[H] Data transfer of characteristic value of scanner
(1) Start up with the Adjustment mode (05).
(2) Enter the password, and then press the [OK] button. (If the password is not set for Service, press
the [OK] button without entering anything.)
(3) Perform Data transfer of characteristic value of scanner (05-3203).
(4) Turn the power OFF.
[I] Reinstall license
* If the license was returned in "[A]Return License", reinstall it with the following procedure.
(1) Turn the power ON while pressing [0] and [8] simultaneously.
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3) Key in [3840], and then press the [START] button.
(4) Press the [INSTALL] button.
(5) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK] button.
(6) Select the license to be installed, and then press the [INSTALL] button.
(7) The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(8) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button.
Then check that the one-time dongle is installed properly in the equipment.
(9) Check that the installed license is displayed on the license list.
Remark:
If there are any other licenses to be installed, repeat from step (4). If there are no other licenses
to be installed, press the [CLOSE] button, and then turn the power OFF.
[J] Check ROM versions
• System ROM version (08-9930)
• Scanner ROM version (08-9902)
Note:
If the security mode is changed from High Security to Low Security in the step "[A]Return
license", set the value of 08-8911 to "3" (High Security).
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
REPLACEMENT OF PC BOARDS / HDD
9 - 25
9