[CCE1] Inserter fan motor abnormality
Is the harness between the inserter control board and inserter fan normal?
NO
YES
Is the conductor pattern around Q11, Q16 and CN8 on the inserter control board short
circuited or open circuited?
NO
YES
Replace the inserter control board.
[CDE0] Paddle motor abnormality
Is the paddle home position sensor (PI26) working normally?
NO
YES
Is the wiring between the finisher controller PC board and the paddle motor (M14) correct?
YES Correct the wiring.
NO
Is the paddle drive mechanism normal?
YES Fix the mechanism.
NO
Is the problem solved by replacing the paddle motor?
NO
YES
END
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Replace the harness.
Replace the inserter fan.
Replace the sensor.
Replace the finisher controller PC board.
8 - 129
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8