Toshiba e-STUDIO556 Service Manual page 197

(6) Disconnect 1 connector and take off the
scanner unit cooling fan.
4.3.19 Platen sensor (S53) (e-STUDIO556/656/756/856)
(1) Take off the top rear cover.
( P.4-3 "4.1.6 Top rear cover")
(2) Take off the rear cover.
( P.4-5 "4.1.13 Rear cover")
(3) Remove 1 clip to take off the actuator.
(4) Disconnect 1 connector and release 2
latches. Then take off the platen sensor.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Scanner unit
cooling fan
Fig. 4-91
Actuator
Clip
Fig. 4-92
Platen sensor
Fig. 4-93
e-STUDIO556/656/756/856/557/657/757/857
4 - 33
DISASSEMBLY AND REPLACEMENT
4