Toshiba e-STUDIO556 Service Manual page 255

(3) Tilt the developer unit and take out the old
developer material by rotating the gear on
the rear side.
(4) Put in the new developer material.
(5) Rotate the gear on the rear side several
times so that the developer material is mixed
evenly.
Note:
When installing the top cover, make sure that
the latches insert completely, the cover does
not catch in the urethane seal and the
urethane sheets are overlapped correctly.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-254
Gear
Fig. 4-255
Fig. 4-256
e-STUDIO556/656/756/856/557/657/757/857
4 - 91
Gear
Urethane seal ( outside )
Urethane seal
( inside )
Urethane seal
DISASSEMBLY AND REPLACEMENT
4