Toshiba e-STUDIO556 Service Manual page 353

Notes:
1. A mode can be canceled by [POWER] OFF/ON when the LED is lit and the LCD is blinking.
2. Button Check
Buttons with LED
Buttons without LED
Button on touch panel
Test mode (03): Refer to  P.5-7 "5.3 Input check (Test mode 03)" and  P.5-8 "5.4 Output check
•
(Test mode 03)".
Test print mode (04): Refer to  P.5-9 "5.5 Test print mode (test mode 04)".
•
Adjustment mode (05): Refer to  P.5-10 "5.6 Adjustment mode (05)".
•
Setting mode (08): Refer to  P.5-13 "5.8 Setting mode (08)".
•
Assist mode (3C): Refer to  P.5-15 "5.9 Assist Mode (3C)".
•
HDD Assist mode (4C): Refer to  P.5-19 "5.10 HDD Assist Mode (4C)".
•
File system recovery mode (5C): Refer to  P.5-23 "5.11 File System Recovery Mode (5C)".
•
SRAM clear mode (6C): Refer to  P.5-28 "5.12 SRAM Clear Mode (6C)".
•
List print mode (9S): Refer to  P.5-31 "5.13 List Print Mode(9S)".
•
• PM support mode (6S):
<Operation procedure>
[6][START]
[POWER]
1: Auto-toner adjustment
2: PM Support Screen
• Firmware update mode (49 or 89): Refer to "11. FIRMWARE UPDATING".
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
(Press to turn OFF the LED.)
(Press to display the message on the control panel.)
(Press to display the initial screen displayed at power-ON.
Press [execution] on the touch panel and then
the [C] button on the control panel.
The screen then returns to the Button Check menu.)
(Code) [START]
(Operation started)
5 - 3
[POWER] OFF/ON
(Exit)
e-STUDIO556/656/756/856/557/657/757/857
SELF-DIAGNOSTIC MODE
5