Toshiba e-STUDIO556 Service Manual page 426

[G] Right margin
<Procedure>
While pressing [0] and [5] simultaneously, turn the power ON.  (Adjustment Mode)
(1)
(2) Open the RADF.
(3) Press [FAX] [START] to make a copy at the mode of A3/LD, 100%, Text/Photo and the 2nd
drawer.
(4) Measure the blank area F at the right side of the copied image.
(5) Check if the blank area F is within the range of 2±1.0 mm.
(6) If not, use the following procedure to change values and repeat the steps (3) to (5) above.
(Adjustment Mode)  (Key in the code [4052])  [START]
 (Key in a value (acceptable values: 0 to 255))
 Press the [OK] or the [INTERRUPT] button (stored in memory).
 ("100% A" is displayed.)
* The larger the adjustment value is, the wider the blank area at the right side becomes
(approx. 0.04 mm/step).
e-STUDIO556/656/756/856/557/657/757/857
ADJUSTMENT
Feeding direction
F
Fig. 6-22
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
6 - 22