Toshiba e-STUDIO556 Service Manual page 181

Notes:
Be sure to install the lamp harness by
following the procedure below.
1. Be sure to pass the lamp harness [1]
under the harness guide [2].
2. Using alcohol, clean the area where the
seal is to be attached.
3. Align the bent portion of the lamp harness
[1] with the position as shown in the
figure, and fix it with a seal [3].
4. After the installation, move carriage-1
towards the left and confirm that there is
no abnormality in the lamp harness (a
part indicated by [4] ) , such as twisting.
(11) Rotate the carriage-1 in the direction shown
in the figure at right, not to touch the mirror.
Then take off the carriage-1.
Note:
When replacing the mirror-1, replace the
carriage-1 together with mirror-1. Mirror-1
should not be removed.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
[1]
[2]
Fig. 4-45
[3]
[1]
[4]
Fig. 4-46
Fig. 4-47
e-STUDIO556/656/756/856/557/657/757/857
4 - 17
DISASSEMBLY AND REPLACEMENT
4