Toshiba e-STUDIO556 Service Manual page 361

Procedure 10
[0][5] [Digital key]
[POWER] (Code)
Procedure 12
[CANCEL]
[Digital key]
[0][5]
(Code)
[POWER]
Procedure 14
[0][5]
[Digital key]
[START]
[POWER]
(Code)
Procedure 17
[ CANCEL ] or [CLEAR]
[0][5]
[Digital key]
[POWER]
(Code)
[ CANCEL ] or [CLEAR]
Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
[Digital key]
[START]
(Sub code)
[SET] or [INTERRUPT]
(Value unchangeable)
[Digital key]
[START]
(Adjust a value)
[ CANCEL ]
[Digital key]
[START]
(Sub code)
[CLEAR]
(Corrects value)
( )
Automatic
[START]
adjustment
(Adjust a value)
( )
Manual
adjustment
(Adjust a value)
5 - 11
( )
Value
[START]
displayed
[CLEAR]
[OK]
[START]
or
(Volume)
[INTERRUPT]
(
Stores value
in RAM
[CLEAR]
(Correction)
[OK]
[UP]or[DOWN]
or
(Adjust a value)
[INTERRUPT]
(
Stores value
in RAM
[CANCEL]
(Corrects value)
[UP] [OK]
or or
[DOWN] [INTERRUPT]
(Stores value)
[UP]
[OK]
or
or
[DOWN] [INTERRUPT]
(Stores value)
e-STUDIO556/656/756/856/557/657/757/857
[POWER]
[START] OFF/ON
(Exit)
[POWER]
OFF/ON
(Exit)
)
[POWER]
([FAX] )
OFF/ON
(Exit)
)
[START]
(Test copy)
[POWER]
[FAX]
OFF/ON
(Exit)
[START]
(Test copy)
SELF-DIAGNOSTIC MODE
5