Toshiba e-STUDIO556 Service Manual page 592

8.3.2 Paper transport jam
[E010] Paper not reaching fuser transport sensor
Classification
Paper exit jam
Check item
Fuser transport sensor
LGC board
Transfer belt unit
Fuser
Drive unit, Rollers
Drum separation finger solenoid
egistration sensor
R
Registration motor
Replace parts
Fuser transport sensor
Drum separation finger solenoid
egistration sensor
R
Registration motor
LGC board
* If the error [E010] caused by a paper jam underneath the drum cleaner often occurs due to an
insufficient paper separation from the photoconductive drum, set a smaller value in the code 08-
2960, and see what happens. At this time, however, pay attention to the transferability at the leading
edge of the paper since this transferability can be slightly narrowed depending on the environments
and conditions under which the equipment is placed or the media type of the paper used.
[E020] Paper stopping at fuser transport sensor
Classification
Paper exit jam
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
Paper which has passed the fuser unit does not reach the fuser transport
sensor
• Sensor check (Perform the input check: 03-[FAX]OFF/[7]/[C])
• Connector check
• Harness check.
• Connector check (CN332, CN339, CN341)
• Board check.
• transfer belt check
• transport motor driving PC board
• Connector check
• Harness check.
• Gear check
• Roller check
• Motor check (Perform the output check:03-111/161)
• Harness check.
• Sensor check (Perform the input check: 03-[FAX]ON/[4]/[E])
• Connector check
• Harness check.
• Motor check (Perform the output check:03-108/158)
• Harness check.
The trailing edge of paper does not pass the fuser transport sensor after its
leading edge has reached the fuser transport sensor.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 40
Error item
Measures
Remarks
Error item