Toshiba e-STUDIO556 Service Manual page 212

[ 6 ] Feed clutch (CLT6/CLT8/CLT10/CLT12) and Transport clutch (CLT5/CLT7/CLT9/
CLT11) (e-STUDIO557/657/757/857)
(1) Disconnect the connectors [1] and [2] from
the feed clutch and the transport clutch.
Remove the harness clamp [3].
Transport clutch Harness [1]: Black
Feed clutch Harness [2]: Purple
(2) Release the harness from the harness guide.
Remove 1 screw and take off the clutch
cover [1].
(3) Remove 1 E-ring from each clutch. Take off
the feed clutch [1] and the transport clutch
[2].
Notes:
1. When installing the clutch, do not insert
the wrong harness.
2. Fit in the protrusion of the clutch to the
stopper.
3. When fixing the clutch with the E-ring, be
sure that the one side of the E-ring latch
does not overlap the flat part of the shaft.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
[1]
[2]
Fig. 4-131
[1]
Fig. 4-132
[1]
[2]
Fig. 4-133
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 48
[3]