Toshiba e-STUDIO556 Service Manual page 180

(6) Remove 1 screw and take off the harness
guide [1].
(7) Peel off the square seal [2] fixing the lamp
harness to the base.
(8) Release the lamp harness [1] from the
harness clamp [2].
(9) Take off the SYS board cover.
( P.9-1 "9.1.1 SYS board cover")
(10) Disconnect the connector of the lamp
harness [1] from the DRV board [3] .
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
[2]
[2]
[1]
[3]
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 16
[1]
Fig. 4-43
[1]
Fig. 4-44