Toshiba e-STUDIO556 Service Manual page 220

(2) Remove 1 clip and take off the separation
roller by lifting the shaft.
[ 5 ] Bypass paper size detection sensor (S28)
(1) Disconnect 1 connector and release it from
the clamp.
(2) Remove 2 brackets on both sides of the tray
and 2 screws each to take off the bypass
tray.
(3) Remove 3 screws and release 4 latches to
take off the bypass tray upper cover.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Separation roller
Fig. 4-154
Screw
Fixing bracket
Fig. 4-155
Bypass tray upper cover
Latch
Screw
Fig. 4-156
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 56
Clip
Connector
Screw
Hook
Latch