Toshiba e-STUDIO556 Service Manual page 328

(5) Remove 3 screws and take off the original
exit motor with the bracket.
(6) Remove 2 screws and take off the bracket
from the original exit motor.
Notes:
When replacing the original exit motor or
disassembling the bracket, adjust the belt
tension following the procedure below.
1. Turn the plate in the direction of the arrow
and fix it with 2 screws temporarily.
2. Install the bracket with the motor in the
RADF.
3. Install spring [2].
4. Loosen 2 screws [1], check that the belt is
made tense with the spring and then
tighten them.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 164
Fig. 4-464
Fig. 4-465
[1]
[1]
Fig. 4-466
[2]