Toshiba e-STUDIO556 Service Manual page 269

(6) Remove 1 clip and then the bushing.
(7) Push the brush to the rear side, take off the
shaft on the front side and then pull it out to
the upper front side.
Note:
Do not touch the surface of the brush.
4.10.4 Cleaning blade
(1) Take off the transfer unit.
( P.4-102 "4.10.1 Transfer unit")
(2) Remove 3 screws to take off the cleaning
blade.
Notes:
1. When installing the blade, fix the boss on
both sides with the screws.
2. Be careful not to touch, scratch or
damage the blade.
3. After installing the blade, be sure that the
seals on both sides are not damaged.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-294
Screw
Fig. 4-295
Urethan seal
Cleaning blade
Fig. 4-296
e-STUDIO556/656/756/856/557/657/757/857
4 - 105
Cleaning brush
Bush
Clip
Cleaning blade
DISASSEMBLY AND REPLACEMENT
4