Toshiba e-STUDIO556 Service Manual page 593

Check item
Fuser transport sensor
LGC board
Fuser
Drive unit, Rollers
Reverse motor
Replace parts
Fuser transport sensor
Reverse motor
LGC board
[E030] Power-ON jam
Classification
Other paper jam
Check item
Cover, Transport pass
Each sensor
LGC board
Drive unit, Rollers
Relation between the jamming area and the corresponding sensors and covers
Jamming area
Registration area
Exit/Reverse area
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
• Sensor check (Perform the input check: 03-[FAX]OFF/[7]/[C])
• Connector check
• Harness check.
• Connector check (CN332, CN335)
• Board check.
• Connector check
• Harness check.
• Gear check
• Roller check
• Motor check (Perform the output check:03-126)
• Harness check.
Paper is remaining on the paper transport path of the equipment when the
power is turned ON
• Open the cover of the unit/area whose picture is flashing on the control
panel and remove if there is any paper on the transport path. (Refer to
the table below.)
• Sensor check (Refer to the following table.)
• Connector check
• Harness check.
• Connector check
• Board check.
• Gear check
• Roller check
Sensor
Registration sensor
Exit sensor
Reverse sensor-1
Reverse sensor-2
Fuser transport sensor
8 - 41
Measures
Remarks
Error item
Measures
Test mode / Input check
03-[FAX]ON/[4]/[E]
03-[FAX]OFF/[7]/[B]
03-[FAX]OFF/[7]/[E]
03-[FAX]OFF/[7]/[D]
03-[FAX]OFF/[7]/[C]
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8