Toshiba e-STUDIO556 Service Manual page 290

4.11.11 Web motor (M4) / Fuser transport sensor (S9)
(1) Take off the fuser unit.
( P.4-115 "4.11.2 Fuser unit")
(2) Take off the cleaning web unit.
( P.4-117 "4.11.3 Cleaning web unit /
Cleaning web")
(3) Remove 2 screws to take off the fuser unit
cover (front).
(4) Remove 2 screws and open the lower
separation finger unit.
(5) Release the harness from the harness end-
holder and then disconnect 1 connector.
(6) Remove 2 screws and take off the web
motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Lower separation finger unit
Web motor
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 126
Fuser unit cover (front)
Fig. 4-350
Fig. 4-351
Fig. 4-352