Toshiba e-STUDIO556 Service Manual page 214

4.6.2 Intermediate transport unit
(1) Take off the first paper feeder unit.
( P.4-44 "4.6.1 Paper feeder unit / Bypass
feed unit")
(2) Disconnect 1 connector and remove 3
screws to take off the intermediate transport
unit.
[ 1 ] Motor driving PC board (MOT2-MT)
(1) Release the harness from the harness
clamp. Then remove 2 screws to take off the
bracket.
Note:
Be careful not to drop the gear because it will
comes out of place when its bracket is taken
off.
(2) Remove 1 screw on the varistor.
(3) Removing 4 screws and 4 bushings to take
off the paper guide.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Fig. 4-137
Fig. 4-138
Paper guide
Varistor
Fig. 4-139
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 50
Intermediate transport unit
Gear
Bracket Gear