Toshiba e-STUDIO556 Service Manual page 268

(3) Remove 2 screws.
(4) Turn the driving roller to the direction of the
arrow.
(5) Pull out the transfer belt.
Notes:
1. Install the transfer belt in the middle so
that it does not move to one side.
2. Do not touch the surface of the belt.
3. Fix the link plate securely by pressing the
rear and front side of the plate to the
direction of the arrow.
4. Pay attention to the parts when taking off
the transfer belt because those for e-
STUDIO556/656/756/856 and e-
STUDIO557/657/757/857 are different.
4.10.3 Cleaning brush
(1) Take off the transfer unit.
( P.4-102 "4.10.1 Transfer unit")
(2) Take off the transfer belt unit.
( P.4-103 "4.10.2 Transfer belt")
(3) Remove 1 clip and then 3 gears.
Notes:
1. There are latches on gear "a" and "c".
Remove gear "a", "b" and then "c".
2. When installing the gear, be sure that the
latch is securely inserted into the groove
of the shaft.
(4) Remove 1 screw and then the plate spring.
(5) Slide the transport guide to the rear side to
pull it out upward.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Screw
Screw
Plate spring
c
a
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 104
Link plate
Screw
Fig. 4-291
Transfer belt
Fig. 4-292
Transport guide
b
Fig. 4-293