Toshiba e-STUDIO556 Service Manual page 218

[ 2 ] Bypass feed clutch (CLT4)
(1) Disconnect the connector and then remove
the harness band and clip to take off the
bypass feed clutch.
Note:
When assembling, be sure that the stopper
of the clutch is securely inserted into the
groove of the bracket.
[ 3 ] Bypass pickup solenoid (SOL3) / Bypass feed sensor (S27)
(1) Remove 5 screws, disconnect 2 connectors
and take off the stay.
(2) Disconnect the connector and take off the
bypass feed sensor.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Connector
Fig. 4-148
Connector Screw
Screw
Fig. 4-149
Stay
Fig. 4-150
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 54
Clip
Bypass feed clutch
Harness band
Stay
Screw
Connector
Bypass feed sensor