Toshiba e-STUDIO556 Service Manual page 961

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

[B] Restoring procedure

Shut down the equipment.

Connect the USB media to the USB port on the right upper cover.

Restoring cannot be performed with multiple USB media connected at the same time.

Turn the power ON while pressing the [5] and [9] buttons simultaneously.

Enter the password, and then press the [OK].

(If the password is not set for Service, press the [OK] without entering anything.)

Select "2. Restore SRAM Data from USB", and then press the [START] button.

Enter a password (max. 15 characters) set for the backup data.

Enter the serial number of the backup file.

"Restore successfully done" is displayed on the LCD screen when the restoring has been

properly completed.

Turn the power OFF after the restoring is completed.

When the back-up file is restored, do not perform HDD partition creation (Format HDD) before

the normal start-up.

To perform cloning with the SRAM data backed up before the ADI-HDD is initialized or

replaced,follow the procedure below after the restoration is finished.

(1) Turn the power ON while pressing [3] and the [CLEAR] button simultaneously.

(2) Enter the password, and then press the [OK] button.

(If no password is set for Service, press the [OK] button without entering anything.)

(3) Key in [5] to select "5. Key Backup Restore", and then press the [START] button.

(4) Key in [6] to select "6. ADIKey FROM to SRAM", and then press the [START] button.

(5) Wait until the restoring of the encryption key is completed. "Operation Complete" is

(6) Then turn the power OFF.

e-STUDIO556/656/756/856/557/657/757/857

BACKUP FUNCTION