Maintaining Mx240 Switch Control Boards; Replacing An Mx240 Scb-Mx - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide
See Also

Maintaining MX240 Switch Control Boards

Replacing an MX240 SCB-MX

326
MX240 PIC Description on page 104
MX240 Modular Port Concentrator (MPC) Description on page 127
MX240 Modular Interface Card (MIC) Description on page 116
Replacing a Cable on an MX240 DPC, MPC, MIC, or PIC on page 294
Removing an SFP or XFP Transceiver from an MX240 DPC, MPC, MIC, or PIC on page 298
Preventing Electrostatic Discharge Damage to an MX240 Router on page 380
MX240 Dense Port Concentrator (DPC) Description on page 93
Preventing Electrostatic Discharge Damage to an MX240 Router on page 380
Replacing an MX240 SCB-MX on page 326
Upgrading an MX240 to Use the SCBE-MX on page 330
Upgrading an MX240 to Use the SCBE2-MX on page 338
Upgrading an MX240, MX480, or MX960 Router to Use the SCBE3-MX on page 343
CAUTION: Before you replace the Switch Control Board, you must take the
host subsystem offline. If there is only one host subsystem, taking the host
subsystem offline shuts down the router.
Before replacing an SCB-MX, read the guidelines in Operating and Positioning the MX240
SCB Ejectors.
Removing an MX240 SCB-MX on page 327
1.
Installing an MX240 Switch Control Board on page 328
2.
Copyright © 2019, Juniper Networks, Inc.