Maintaining Mx240 Switch Control Boards - Juniper MX240 Hardware Manual

WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to a transceiver emit laser light that can damage your eyes.
8. Verify that the status LEDs on the component faceplate indicate that the SFP or XFP is functioning
correctly. For more information about the component LEDs, see the
SEE ALSO
MX240 Dense Port Concentrator (DPC) Description | 113
MX240 PIC Description | 125
MX240 Modular Port Concentrator (MPC) Description | 154
MX240 Modular Interface Card (MIC) Description | 139
Replacing a Cable on an MX240 DPC, MPC, MIC, or PIC | 359
Removing an SFP or XFP Transceiver from an MX240 DPC, MPC, MIC, or PIC | 363
Preventing Electrostatic Discharge Damage to an MX240 Router | 467
SEE ALSO
MX240 Dense Port Concentrator (DPC) Description | 113
Preventing Electrostatic Discharge Damage to an MX240 Router | 467

Maintaining MX240 Switch Control Boards

IN THIS SECTION
Replacing an MX240 SCB-MX | 401
Upgrading an MX240 to Use the SCBE-MX | 404
Upgrading an MX240 to Use the SCBE2-MX | 414
Upgrading an MX240, MX480, or MX960 Router to Use the SCBE3-MX | 419
Do not look directly into a fiber-optic transceiver or into the ends
MX Series Interface Module Reference.
400