MX240 3D Universal Edge Router Hardware Guide
SCB LEDs on the MX240 Craft Interface
Fan LED on the MX240 Craft Interface
Related
Documentation
16
Table 10: FPC LEDs on the Craft Interface
Label
Color
Green
OK
–
Red
FAIL
Each SCB has two LEDs on the craft interface that indicates its status. The SCB LEDs,
labeled
and
(
shows the status of either SCB1 DPC0, or FPC0 depending on
0
1/0
1/0
which component is installed in the multifunction slot), are located along the bottom of
the craft interface.
Table 11 on page 16
Table 11: SCB LEDs on the Craft Interface
Label
Color
OK
Green
–
Red
FAIL
The fan LEDs are located on the top left of the craft interface.
describes the functions of the fan LEDs.
Table 12: Fan LEDs on the Craft Interface
Label
Color
Green
FAN
Red
MX240 Craft Interface Overview on page 12
MX240 Alarm LEDs and Alarm Cutoff/Lamp Test Button on page 13
MX240 Alarm Relay Contacts on the Craft Interface on page 13
State
Description
On steadily
FPC is functioning normally.
Blinking
FPC is transitioning online or offline.
Off
The slot is not online.
On steadily
FPC has failed.
describes the functions of the SCB LEDs.
State
Description
On steadily
SCB: Fabric and control board functioning normally.
Blinking
SCB is transitioning online or offline.
Off
The slot is not online.
On steadily
SCB has failed.
State
Description
On steadily
Fan is functioning normally.
On steadily
Fan has failed.
Table 12 on page 16
Copyright © 2017, Juniper Networks, Inc.