Installing An Mx240 Mpc; Figure 121: Removing An Mpc - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide
See Also
286

Figure 121: Removing an MPC

MPC
SC B
SC B
MX240 Modular Port Concentrator (MPC) Description on page 127
MX240 MPC Serial Number Label on page 368
Preventing Electrostatic Discharge Damage to an MX240 Router on page 380

Installing an MX240 MPC

An MPC installs horizontally in the front of the router. The MPCs are hot-insertable and
hot-removable. A fully configured MPC can weigh up to 18.35 lb (8.3 kg). Be prepared to
accept its full weight.
To install an MPC (see Figure 122 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Place the MPC on an antistatic mat.
2.
Take each MIC to be installed in the replacement MPC out of its electrostatic bag and
3.
identify the slot on the MPC where it will be connected.
Verify that each fiber-optic MIC has a rubber safety cap covering the MIC transceiver.
4.
If it does not, cover the transceiver with a safety cap.
Install each MIC into the appropriate slot on the MPC.
5.
Locate the slot in the card cage in which you plan to install the MPC.
6.
Orient the MPC so that the faceplate faces you.
7.
Lift the MPC into place and carefully align the sides of the MPC with the guides inside
8.
the card cage.
288):
Copyright © 2019, Juniper Networks, Inc.