Figure 116: Attaching a Cable to a DPC
SEE ALSO
Preventing Electrostatic Discharge Damage to an MX480 Router | 477
MX480 Dense Port Concentrator (DPC) Description | 109
MX480 Dense Port Concentrator (DPC) LEDs | 115
Troubleshooting the MX480 DPCs | 438
Replacing a Cable on an MX480 DPC, MPC, MIC, or PIC
Removing a Cable on an MX480 DPC, MPC, MIC, or PIC | 334
1.
Installing a Cable on an MX480 DPC, MPC, MIC, or PIC | 336
2.
Removing a Cable on an MX480 DPC, MPC, MIC, or PIC
Removing and installing cables on a DPC, MPC, MIC, or PIC does not affect router function.
To remove a cable:
1. Have ready a rubber safety cap for each fiber-optic cable and transceiver.
2. If removing all cables connected to the component, use one of the following methods to take the
component offline:
To take a DPC or an MPC offline:
Press and hold the corresponding online button on the craft interface. The green OK LED next to
the button begins to blink. Hold the button down until the LED goes off.
Issue the following CLI command:
Fiber-optic cable
connector
334