Replacing A Cable On An Mx960 Dpc, Mpc, Mic, Or Pic; Removing A Cable On An Mx960 Dpc, Mpc, Mic, Or Pic - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide

Replacing a Cable on an MX960 DPC, MPC, MIC, or PIC

Removing a Cable on an MX960 DPC, MPC, MIC, or PIC

386
MX960 PIC Description on page 66
Removing a Cable on an MX960 DPC, MPC, MIC, or PIC on page 386
Installing a Cable on an MX960 DPC, MPC, MIC, or PIC on page 387
Removing and installing cables on a DPC, MPC, MIC, or PIC does not affect router function,
except that the component does not receive or transmit data while its cable is
disconnected.
To remove a fiber-optic cable:
If the component connects to fiber-optic cable, have ready a rubber safety cap for
1.
each cable and transceiver.
If removing all cables connected to the component, use one of the following methods
2.
to take the component offline:
To take a DPC or an MPC offline:
Press and hold the corresponding online button on the craft interface. The green
LED next to the button begins to blink. Hold the button down until the LED
OK
goes off.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number offline
For more information about the command, see the
To take a PIC offline:
Press the online/offline button on the PIC. For a PIC installed in an FPC3, use a
narrow-ended tool that fits inside the opening that leads to the button. Press and
hold the button until the PIC LED goes out (about 5 seconds).
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot offline
For more information about the command, see the
To take a MIC offline:
Press the online/offline button on the MIC. Use a narrow-ended tool that fits
inside the opening that leads to the button. Press and hold the button until the
MIC LED goes off (about 5 seconds).
Issue the following CLI command:
user@host> request chassis mic fpc-slot mpc-slot pic-slot mic-slot offline
CLI Explorer .
.
CLI Explorer
Copyright © 2017, Juniper Networks, Inc.