Omron NX701-17 Series Troubleshooting Manual page 52

1 Overview of Errors
Method
Cycling the Control-
ler's power supply
Cycling the power
supply to the Slave
Terminal
*1 Some errors are reset when the EtherCAT communications link is established rather than when the reset oper-
ation is performed.
*2 To reset errors from an HMI, connect the HMI to the built-in EtherNet/IP port on the CPU Unit.
Refer to the Sysmac Studio Version 1 Operation Manual (Cat. No. W504) for details on clearing errors
from the Sysmac Studio.
1-24
Errors that are
Operation
reset
--- Resets all errors.
--- Resetting all Slave
Terminal errors
Description
After the causes of the Controller errors are
removed, all Controller errors in all function
modules are reset as a result.
If the causes for the Controller errors are
removed, all Controller errors in the Slave
Terminals are reset.
NJ/NX-series Troubleshooting Manual (W503)