Omron NX701-17 Series Troubleshooting Manual page 124

3 Error Tables
Event code Event name
54015450 hex Trigger Input Con-
dition Mode Selec-
tion Out of Range
54015451 hex Drive Trigger Sig-
nal Selection Out
of Range for Trig-
ger Input Condition
54015453 hex Motion Control
Instruction Re-exe-
cution Disabled
(Axis Specification)
54015454 hex Motion Control
Instruction Re-exe-
cution Disabled
(Buffer Mode
Selection)
54015455 hex Motion Control
Instruction Re-exe-
cution Disabled
(Direction Selec-
tion)
54015456 hex Motion Control
Instruction Re-exe-
cution Disabled
(Execution Mode)
54015457 hex Motion Control
Instruction Re-exe-
cution Disabled
(Axes Group Spec-
ification)
54015458 hex Motion Control
Instruction Re-exe-
cution Disabled
(Jerk Setting)
3-46
Meaning
The parameter specified for • Instruction input
the TriggerInput:: Mode
input variable to a motion
control instruction is out of
range.
The parameter specified for • Instruction input
the TriggerInput::Input-
Drive input variable to a
motion control instruction is
out of range.
An attempt was made to • A parameter for an
change the parameter for
the Axis input variable
when re-executing a motion
control instruction. (This
input variable cannot be
changed when re-execut-
ing an instruction.)
An attempt was made to • A parameter for an
change the parameter for
the BufferMode input vari-
able when re-executing a
motion control instruction.
(This input variable cannot
be changed when re-exe-
cuting an instruction.)
An attempt was made to • An input variable that
change the parameter for
the Direction input variable
when re-executing a motion
control instruction. (This
input variable cannot be
changed when re-execut-
ing an instruction.)
An attempt was made to • A parameter for an
change the parameter for
the Periodic input variable
when re-executing a motion
control instruction. (This
input variable cannot be
changed when re-execut-
ing an instruction.)
An attempt was made to • A parameter for an
change the parameter for
the AxesGroup input vari-
able when re-executing a
motion control instruction.
(This input variable cannot
be changed when re-exe-
cuting an instruction.)
An attempt was made to • A parameter for an
change the parameter for
the Jerk input variable
when re-executing a motion
control instruction. (This
input variable cannot be
changed when re-execut-
ing an instruction.)
Assumed cause
Maj Prt
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
input variable that
cannot be changed for
re-execution was
changed.
input variable that
cannot be changed for
re-execution was
changed.
cannot be changed for
re-execution was
changed.
input variable that
cannot be changed for
re-execution was
changed.
input variable that
cannot be changed for
re-execution was
changed.
input variable that
cannot be changed for
re-execution was
changed.
NJ/NX-series Troubleshooting Manual (W503)
Level
Refer-
ence
Min Obs Info
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502