Omron NX701-17 Series Troubleshooting Manual page 151

Event code Event name
54200000 hex Electronic
Gear Ratio
Numerator
Setting Out of
Range
54210000 hex Electronic
Gear Ratio
Denominator
Setting Out of
Range
54220000 hex Target Veloc-
ity Setting
Out of Range
54230000 hex Acceleration
Setting Out of
Range
54240000 hex Deceleration
Setting Out of
Range
54250000 hex Jerk Setting
Out of Range
54270000 hex Torque Ramp
Setting Out of
Range
54280000 hex Master Coef-
ficient Scal-
ing Out of
Range
54290000 hex Slave Coeffi-
cient Scaling
Out of Range
542A0000 hex Feeding
Velocity Set-
ting Out of
Range
NJ/NX-series Troubleshooting Manual (W503)
Meaning Assumed cause
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
RatioNumerator input variable.
input variable to a
motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
RatioDenominator input variable.
input variable to a
motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Velocity input vari- input variable.
able to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Acceleration input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Deceleration input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Jerk input variable input variable.
to a motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
TorqueRamp input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MasterScaling input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
SlaveScaling input input variable.
variable to a motion
control instruction is
out of range.
The parameter • The Feed Velocity (input vari-
specified for the able FeedVelocity) is still at the
FeedVelocity input default (0).
variable to a motion
control instruction is
out of range.
3 Error Tables
Level
Maj Prt Min Obs Info
S W508
S W508
S W508
S W508
S W508
S W508
S W508
S W508
S W508
S W508
Reference
3
3-73