3-1-14 Errors In Cj-Series Units - Omron NX701-17 Series Troubleshooting Manual

Machine automation controller nj/nx-series
Hide thumbs Also See for NX701-17 Series:
Table of Contents

Advertisement

3-1-14 Errors in CJ-series Units

The section provides tables of the errors (events) that can occur in the following CJ-series Units.
• Analog I/O Units
• Process I/O Units
• Temperature Control Units
• ID Sensor Units
• High-speed Counter Units
• Serial Communications Units
• DeviceNet Units
• EtherNet/IP Units
• CompoNet Master Units
CJ-series Analog I/O Units
The section provides tables of the errors (events) that can occur in the following Units.
CJ1W-AD041-V1/AD081-V1
CJ1W-AD042
CJ1W-DA021/DA041
CJ1W-DA08V/DA08C
CJ1W-DA042V
CJ1W-MAD42
The manual names are given below for the catalog numbers given in the Reference column of the
event table.
Cat. No.
W490
Event code
Event name
04600000 hex
A/D Conver-
sion Error
04620000 hex
Non-volatile
Memory
Error
34800000 hex
Mean Value
Processing
Setting Error
34830000 hex
Scaling Data
Setting Error
34840000 hex
Input Signal
Range Set-
ting Error or
Error in Num-
ber of Inputs
Setting
NJ/NX-series Troubleshooting Manual (W503)
CJ-series Analog I/O Units Operation Manual for NJ-series CPU Unit
Meaning
Assumed cause
An error occurred in
• There is a source of noise
A/D conversion.
nearby.
• A/D converter failed.
An error occurred in
• There is a source of noise
non-volatile mem-
nearby.
ory.
• Non-volatile memory failed.
There is a mistake
• There is a mistake in the setting
in the setting of the
of the number of samplings for
number of sam-
mean value processing.
plings for mean
value processing.
There is a mistake
• The upper or lower limit data for
in the scaling data
scaling is outside the setting
settings.
range. Or, the maximum value
and minimum value are not 0
and they are the same.
There is a mistake
• The settings of the input signal
in the input signal
range or the setting of the num-
range setting or in
ber of analog inputs that are
the number of
used is incorrect.
inputs setting.
Manual name
Level
Maj
Prt
Min
Obs Info
S
U
S
S
S
S
3 Error Tables
3
Reference
W490
W490
W490
W490
W490
3-223

Advertisement

Table of Contents
loading

Table of Contents