Omron NX701-17 Series Troubleshooting Manual page 166

3 Error Tables
Event code Event name
549A0000 hex Master Axis
Position Type
Selection Out
of Range
549B0000 hex Auxiliary Axis
Position Type
Selection Out
of Range
549C 0000 hex Target Posi-
tion Ring
Counter Out
of Range
549D 0000 hex Axes Group
(Ver. 1.01 or Composition
later) Axis Setting
Out of Range
549E0000 hex Axis Use Set-
(Ver. 1.04 or ting Out of
later) Range
57000000 hex Homing
(Ver. 1.03 or Parameter
later) Setting Out of
Range
57020000 hex Axis Use
(Ver. 1.04 or Change Error
later)
57030000 hex Cannot
(Ver. 1.06 or Change Axis
later) Use
3-88
Meaning Assumed cause
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
ReferenceType- input variable.
Master input vari-
able to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
ReferenceTypeAux- input variable.
iliary input variable
to a motion control
instruction is out of
range.
Operation is not • High-speed homing was exe-
possible because cuted when 0 was not included
the target position in the ring counter.
is out of range for
the ring counter of
the executed
instruction.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Axes input variable input variable.
to a motion control
• The composition axes in the
instruction is out of
axes group are not assigned to
range.
the same task.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
AxisUse input vari- input variable.
able to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
HomingParameter input variable.
input variable to a
motion control
instruction is out of
range.
The • The MC_ChangeAxisUse
MC_ChangeAxis- (Change Axis Use) instruction
Use (Change Axis was executed when the axis
Use) instruction was not stopped or when the
was executed when command velocity of the axis
the axis was not was saturated.
stopped or when
the command
velocity of the axis
was saturated.
The • The MC_ChangeAxisUse
MC_ChangeAxis- (Change Axis Use) instruction
Use (Change Axis was executed in a way that
Use) instruction would cause the maximum
was executed in a number of used real axes to be
way that would exceeded.
cause the maxi-
• The MC_ChangeAxisUse
mum number of
(Change Axis Use) instruction
used real axes or
was executed in a way that
the maximum num-
would cause the maximum
ber of used motion
number of used motion control
control servo axes
servo axes to be exceeded.
to be exceeded.
Level
Maj Prt Min Obs Info
S
S
S
S
S
S
S
S
NJ/NX-series Troubleshooting Manual (W503)
Reference
W508
W508
W508
W508
W508
W508
W508
W508