Omron NX701-17 Series Troubleshooting Manual page 296

3 Error Tables
Event code Event name
385A0000 hex Change in
Connected
Camera
385B0000 hex Light installa-
tion error
48020000 hex System Error
58210000 hex Output Con-
trol Timeout
for Parallel
I/O, PLC
Link, or Eth-
erNet/IP
58220000 hex Output Con-
trol Timeout
for EtherCAT
58230000 hex Initial scene
group error
58240000 hex Initial scene
number error
78190000 hex Image Log-
ging Disk
Write Error
3-218
Meaning Assumed cause
The Camera that is • The Camera connection infor-
connected is differ- mation in the scene data does
ent from when data not agree with the connection
was last saved. information for the Camera con-
nected to the Controller.
The Light installa- • The power consumption of the
tion is incorrect. light installed onto a camera
with a Lighting Controller is
incorrect.
• The lighting mode of the light
installed onto a camera with a
Lighting Controller is incorrect.
• No external power supply is
connected to the camera with a
Lighting Controller.
An error occurred in • A serious error occurred in the
the system. system in the Controller.
A timeout occurred • The data output handshaking
in data output hand- controls in the program (i.e., the
shaking control for ON/OFF timing of the DSA sig-
measurement nal) are not correct.
results.
• The output control timeout time
is too short in comparison with
the program processing time.
• The parallel I/O DSA or Result
Notification signal is not wired
correctly.
A timeout occurred • The data output handshaking
in data output hand- controls in the program (i.e., the
shaking control for ON/OFF timing of the Result
measurement Set Request signal) are not cor-
results. rect.
• The output control timeout time
is too short in comparison with
the program processing time.
Initial scene group • The external storage specified
setting is incorrect. as the scene group destination
by the Scene Group Saving
Destination Settings tool is not
connected at the time of
startup.
• The destination directory is not
detected at the time of startup.
• Initial scene group number is
not within the range of scene
group accepted by the system.
Initial scene num- • Initial scene number is not
ber setting is incor- within the range of scenes
rect. accepted by the system.
Writing data to the • A logging disk is not inserted.
image logging disk
• The available space on the log-
failed.
ging disk is not sufficient.
• There is no logging folder.
• Security restrictions are set on
the logging disk.
Level
Maj Prt Min Obs Info
S
S
S
S
S
S
S
S
NJ/NX-series Troubleshooting Manual (W503)
Reference
Z342
Z342
Z342
Z342
Z342
Z342
Z342
Z342