Omron NX701-17 Series Troubleshooting Manual page 270

3 Error Tables
Event code Event name
84860000 hex Warning-level
Device Event
Flag
84820000 hex IO-Link
Device Con-
figuration
Information
Created
84850000 hex I/O Power
Supply ON
Detected
Servo 1S (1S-series AC Servo Drives with Built-in EtherCAT
Communications) R88M-1 and R88D-1SN-ECT
The section provides a table of the errors (events) that can occur in R88M-1 (AC Servomotors) or
R88D-1SN-ECT (AC Servo Drives).
The manual name is given below for the catalog numbers given in the Reference column of the event
table.
Cat. No.
I586
Event code Event name
05430000 hex ESC Error
08390000 hex Power Mod-
ule Error
083B0000 hex Self-diagno-
sis Error
083C 0000 hex Main Circuit
Temperature
Monitoring
Circuit Fail-
ure
3-192
Meaning
A warning-level Use CX-Configurator FDT to con-
event occurred in firm the event code of the IO-Link
the IO-Link device.
device.
IO-Link device IO-Link device configuration infor-
configuration mation was created.
information was
created.
The I/O power The I/O power supply ON was
supply ON was detected in several times.
detected in sev-
eral times.
AC Servomotors/Servo Drives 1S-series with Built-in EtherCAT Communications User's Man-
ual
Meaning
An error occurred • Error of the EtherCAT slave
in the EtherCAT communications controller or
slave communi- false detection when the AL
cations controller. status code is 0051 hex
• Error access from the non-
OMRON EtherCAT master
when the AL status code is
0050 hex
An error was • There is a short-circuit, ground
detected in the fault, or contact failure on the U,
power module. V, or W motor cable
• There is a short-circuit on the
wiring of External Regenera-
tion Resistor or the resistance
value is small
• The insulation resistance failed
between the U, V, or W motor
cable and the motor ground
wire
• Servo Drive failure
An error was • False detection due to a data
detected by the read error that was caused by
self-diagnosis of excessive noise
the safety func-
• Hardware failure
tion.
A temperature • Broken wiring of the thermistor,
monitoring circuit temperature monitoring circuit
failure was failure
detected on the
main circuit.
Assumed cause
Maj
Manual name
Assumed cause
Maj
NJ/NX-series Troubleshooting Manual (W503)
Level
Refer-
ence
Prt Min Obs Info
S W570
S W570
S W570
Level
Refer-
ence
Prt Min Obs Info
S I586
S I586
S I586
S I586