Omron NX701-17 Series Troubleshooting Manual page 273

Event code Event name
28080000 hex Main Circuit
Power Sup-
ply Phase
Loss Error
280D0000 hex Runaway
Detected
357D0000 hex DC Setting
Error
357E0000 hex Synchroniza-
tion Cycle
Setting Error
357F 0000 hex Mailbox Set-
ting Error
35800000 hex RxPDO Set-
ting Error
35810000 hex TxPDO Set-
ting Error
35820000 hex RxPDO Map-
ping Error
35830000 hex TxPDO Map-
ping Error
35840000 hex PDO WDT
Setting Error
35850000 hex Node
Address
Updated
35860000 hex SM Event
Mode Set-
ting Error
NJ/NX-series Troubleshooting Manual (W503)
Meaning Assumed cause
The phase loss of • Incorrect wiring, for example
the main circuit the single-phase power supply
power supply is input to a 3-phase input type
was detected. Servo Drive
• In the case where the single-
phase power supply is input to
a single- and 3-phase input
type Servo Drive, the phase
loss detection is enabled.
• The power supply voltage is low
or insufficient
• Broken wiring of the main circuit
power supply input
• Servo Drive failure
The motor
• There is incorrect wiring of
rotated in the
the motor cable or a broken
direction opposite cable.
to the command.
• The motor rotated in the
direction opposite to the com-
mand by external forces.
A mistake was • A mistake was made in the DC
made in the DC Mode operation setting
Mode operation
setting.
When the DC • The variable PDO mapping is
mode was estab- used, and the number of
lished, the cycle objects is more than the maxi-
time was set to mum number of mapped
the inoperable objects for the cycle time
value.
• The cycle time setting is incor-
rect
An incorrect mail- • An incorrect mailbox setting of
box setting of Sync Manager was detected
Sync Manager
was detected.
An RxPDO set- • The RxPDO setting of Ether-
ting error was CAT master is incorrect
detected.
• Servo Drive failure
A TxPDO setting • The TxPDO setting of Ether-
error was CAT master is incorrect
detected.
• Servo Drive failure
An incorrect • An incorrect RxPDO was set,
RxPDO was set. such as out of the allowable
range of Index, Subindex, or
size
An incorrect • An incorrect RxPDO was set,
TxPDO was set. such as out of the allowable
range of Index, Subindex, or
size
An incorrect PDO • An incorrect PDO WDT setting
WDT setting was was detected
detected.
The node • The node address is changed
address is from a set value in Sysmac Stu-
changed to a dio to a value of the ID switches
value of the ID
switches.
The unsupported • The unsupported SM Event
SM Event Mode Mode was set
was set.
3 Error Tables
Level
Maj Prt Min Obs Info
S
S
S
S
S
S
S
S
S
S
S
S
Refer-
ence
I586
I586
3
I586
I586
I586
I586
I586
I586
I586
I586
I586
I586
3-195