Omron NX701-17 Series Troubleshooting Manual page 226

3 Error Tables
Event code Event name
5401561F hex Illegal Load
NC Program
Number
Specification
54015620 hex Too Many
Files Open
54015621 hex File or Direc-
tory Name Is
Too Long
54015622 hex SD Memory
Card Access
Failed
54015623 hex Load NC Pro-
gram Capac-
ity Exceeded
54015624 hex Number of
NC Program
Exceeded
54015625 hex Illegal CNC
Motor Speci-
fication
54015626 hex Illegal CNC
Motor Com-
pensation
Table Specifi-
cation
54015628 hex Illegal Load
NC Program
54016783 hex Target Posi-
tion Positive
Software
Limit
Exceeded
3-148
Meaning Assumed cause
Loading failed • An attempt was made to load
because an attempt the NC program with an invalid
was made to load program number specified.
the NC program
with an invalid pro-
gram number speci-
fied.
The maximum num- • The maximum number of open
ber of open files files was exceeded when open-
was exceeded ing a file for an instruction.
when opening a file
for an instruction.
The file name or • The file name or directory name
directory name that that was specified for the
was specified for an instruction to create is too long.
instruction is too
long.
SD Memory Card • The SD Memory Card is dam-
access failed. aged.
• The SD Memory Card slot is
broken.
Loading failed • An attempt was made to load
because an attempt the NC program over the maxi-
was made to load mum capacity.
the NC program
over the maximum
capacity.
Loading failed • A new NC program was loaded
because an attempt while the number of loaded NC
was made to load programs reaches the maxi-
NC programs over mum.
the maximum num-
ber of NC pro-
grams.
The CNC motor • A CNC motor does not exist for
specified for the the variable specified for the
Target in-out Target input variable to the
variable to a CNC instruction.
instruction is not
exist.
The CNC motor • A CNC motor compensation
compensation table table does not exist for the vari-
specified for the able specified for the Target
Target input vari- input variable to the instruction.
able to a CNC
instruction is not
exist.
An error was • A syntax error was detected in
detected in the the NC program you made an
loaded NC pro- attempt to load.
gram.
The specified posi- • The parameter specified for the
tion exceeds the Position input variable to the
positive software instruction is beyond the posi-
limit. tive software limit.
• The first position is beyond the
positive software limit and an
instruction that specifies motion
in the opposite direction of the
software limit was executed.
Level
Maj Prt Min Obs Info
S
S
S
S
S
S
S
S
S
S
NJ/NX-series Troubleshooting Manual (W503)
Reference
O030
O030
O030
O030
O030
O030
O030
O030
O030
O030