Omron NX701-17 Series Troubleshooting Manual page 290

3 Error Tables
Event code Event name
38560000 hex Motor Auto-
setting Error
64E00000 hex Drive Prohibi-
tion Input
Error 1
64E10000 hex Drive Prohibi-
tion Input
Error 2
64E20000 hex Immediate
Stop Input
Error
3-212
Meaning Assumed cause
The current • The Current Loop Proportional
exceeded the limit Gain or the Current Loop Inte-
when it was applied gral Gain was too large before
to the Motor when auto-setting was performed.
the Servo was
locked or when FFT
measurement
preparations were
performed.
When the Drive • A problem occurred with the
Prohibition Input switches, wires, and power
Selection (3504 supplies that are connected to
hex) was set to 0, the Forward/Positive Drive Pro-
both the For- hibition Input (POT) and
ward/Positive Drive Reverse/Negative Drive Prohi-
Prohibition Input bition Input (NOT).
(POT) and
Reverse/Negative
Drive Prohibition
Input (NOT) turned
ON. Or, when the
Drive Prohibition
Input Selection
(3504 hex) was set
to 2, either the For-
ward/Positive Drive
Prohibition Input
(POT) or
Reverse/Negative
Drive Prohibition
Input (NOT) turned
ON.
An operation com- • A problem occurred with the
mand (such as a switches, wires, and power
trial run of FFT) was supplies that are connected to
received from the the Forward/Positive Drive Pro-
CX-Drive when the hibition Input (POT) and
Drive Prohibition Reverse/Negative Drive Prohi-
Input Selection bition Input (NOT).
(3504 hex) was set
to 0, EtherCAT
communications
was interrupted,
and either POT or
NOT was ON. Or,
POT or NOT turned
ON while operation
was being per-
formed for a CX-
Drive operation
command.
An Immediate Stop • An Immediate Stop (STOP) sig-
(STOP) signal was nal was input.
input.
• Incorrect wiring of the immedi-
ate stop input (STOP).
Level
Maj Prt Min Obs Info
S
S
S
S
NJ/NX-series Troubleshooting Manual (W503)
Reference
I577
I576, I577
I576, I577
I576, I577