Omron NX701-17 Series Troubleshooting Manual page 164

3 Error Tables
Event code Event name
54880000 hex Permitted
Following
Error Out of
Range
54890000 hex Border
Point/Center
Posi-
tion/Radius
Specification
Out of Range
548A0000 hex End Point
Specification
Out of Range
548B0000 hex Slave Travel
Distance
Specification
Out of Range
548C 0000 hex Phase Shift
Amount Out
of Range
548D 0000 hex Feeding Dis-
tance Out of
Range
548E0000 hex Auxiliary and
Slave
Defined as
Same Axis
548F 0000 hex Relative
Position
Selection Out
of Range
54900000 hex Cam Transi-
tion Specifi-
cation Out of
Range
3-86
Meaning Assumed cause
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
PermittedDeviation input variable.
input variable to a
motion control
instruction is out of
range.
The parameter • The value of AutPoint
specified for the exceeded signed 40-bit data
AuxPoint input vari- when converted to pulses for
able to a motion the border point or center spec-
control instruction is ification method.
out of range.
• For a radius specifications, the
absolute value of AuxPoint[0]
exceeded 40-bit data when
converted to pulses.
The parameter • The instruction input parameter
specified for the exceeded the range of signed
EndPoint input vari- 40-bit data when it is converted
able to a motion to pulses.
control instruction is
out of range.
The parameter • The instruction input parameter
specified for the exceeded the range of 40-bit
SlaveDistance input data when it is converted to
variable to a motion pulses.
control instruction is
out of range.
The parameter • The absolute value of the
specified for the instruction input parameter
PhaseShift input exceeded the range of 40-bit
variable to a motion data when it is converted to
control instruction is pulses.
out of range.
The parameter • The absolute value of the
specified for the instruction input parameter
FeedDistance input exceeded the range of 40-bit
variable to a motion data when it is converted to
control instruction is pulses.
out of range.
The same axis was • The parameter is the same for
specified for the the Auxiliary and Slave input
Auxiliary and Slave variables to the instruction.
input variables to a
motion control
instruction.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Relative input vari- input variable.
able to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
CamTransition input variable.
input variable to a
motion control
instruction is out of
range.
Level
Maj Prt Min Obs Info
S
S
S
S
S
S
S
S
S
NJ/NX-series Troubleshooting Manual (W503)
Reference
W508
W508
W508
W508
W508
W508
W508
W508
W508