Omron NX701-17 Series Troubleshooting Manual page 110

3 Error Tables
Event code Event name
54011C01 hex Incorrect Route
Path
54011C02 hex CIP Handle Out of
Range
54011C03 hex CIP Communica-
tions Resource
Overflow
54011C04 hex CIP Timeout
54011C05 hex Class-3 Connec-
(Ver. 1.06 or tion Not Estab-
later) lished
3-32
Meaning
The format of the route • The format of the
path that is specified for a
CIP communications
instruction is not correct.
The handle that is specified • The handle that is
for the CIP communications
instruction is not correct.
The maximum resources • More than 32 CIP
that you can use for CIP
communications instruc-
tions at the same time was
exceeded.
• An attempt was made
A CIP timeout occurred
• A device does not
during execution of a CIP
communications instruc-
tion.
• The CIP connection
• Power to the remote
• Communications are
• The Ethernet cable
• The Ethernet cable for
• Noise
Establishing a class-3 con- • The CIPOpen instruc-
nection failed for a CIP
communications instruc-
tion.
• The CIPOpenWithDa-
Assumed cause
Maj Prt
route path that is
specified for a CIP
communications
instruction is not cor-
rect.
specified for the CIP
communications
instruction is not cor-
rect.
communications
instructions were exe-
cuted at the same
time.
to use more than 32
handles at the same
time.
exist for the specified
IP address.
for the specified han-
dle timed out and was
closed.
device is OFF.
stopped at the remote
device.
connector for Ether-
Net/IP is discon-
nected.
EtherNet/IP is discon-
nected.
tion was executed for
a device that does not
support class 3
(Large_For-
ward_Open).
taSize instruction was
executed with a speci-
fied data size of 510
bytes or larger for a
device that does not
support class 3
(Large_For-
ward_Open).
NJ/NX-series Troubleshooting Manual (W503)
Level
Refer-
ence
Min Obs Info
S W502
S W502
S W502
S W502
S W502