Omron NX701-17 Series Troubleshooting Manual page 156

3 Error Tables
Event code Event name
54490000 hex Circular Inter-
polation Cen-
ter
Specification
Position Out
of Range
544A0000 hex Instruction
Execution
Error Caused
by Count
Mode Setting
544C 0000 hex Parameter
Selection Out
of Range
544D 0000 hex Stop Method
Selection Out
of Range
544E0000 hex Latch ID
Selection Out
of Range for
Trigger Input
Condition
544F 0000 hex Setting Out of
Range for
Writing MC
Setting
54500000 hex Trigger Input
Condition
Mode Selec-
tion Out of
Range
54510000 hex Drive Trigger
Signal Selec-
tion Out of
Range for
Trigger Input
Condition
3-78
Meaning Assumed cause
The position speci- • The difference between the dis-
fied for the center tance from the start point to the
point exceeded the center point and the distance
allowed range between the end point to the
when the center center point exceeded the per-
method was speci- mitted value specified for the
fied for the correction allowance ratio in the
MC_MoveCircu- axes group settings when the
lar2D (Circular 2D center designation method was
Interpolation) specified for the MC_MoveCir-
instruction. cular2D (Circular 2D Interpola-
tion) instruction.
An instruction that • An instruction that cannot be
cannot be used used when the Count Mode is
when the Count set to Rotary Mode was exe-
Mode is set to cuted for an axis that was set to
Rotary Mode was Rotary Mode.
executed for an
axis that was set to
Rotary Mode.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
ParameterNumber input variable.
input variable to a
motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
StopMode input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
TriggerIn- input variable.
put::LatchID input
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
SettingValue input
input variable.
variable to a motion
• The parameter specification
control instruction is
and the data type of the setting
out of range.
value do not agree.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
TriggerInput:: Mode input variable.
input variable to a
motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
TriggerInput::Input- input variable.
Drive input variable
to a motion control
instruction is out of
range.
Level
Maj Prt Min Obs Info
S
S
S
S
S
S
S
S
NJ/NX-series Troubleshooting Manual (W503)
Reference
W508
W508
W508
W508
W508
W508
W508
W508