Omron NX701-17 Series Troubleshooting Manual page 129

Event code Event name
54015478 hex Target Position
Setting Out of
Range
54015479 hex Travel Distance
Out of Range
5401547A hex Cam Table Start
Point Setting Out
of Range
5401547B hex Cam Master Axis
Following First
Position Setting
Out of Range
5401547C hex Circular Interpola-
tion Radius Set-
ting Error
5401547D hex Circular Interpola-
tion Radius Over-
flow
5401547E hex Circular Interpola-
tion Setting Out of
Range
NJ/NX-series Troubleshooting Manual (W503)
Meaning
The parameter specified for • Instruction input
the Position input variable
to a motion control instruc-
tion is out of range.
• The target position of
The parameter that was • The absolute value of
specified for the Distance
input variable to a motion
control instruction is out of
range or the target position
with the value of Distance
added is out of range.
• For a Linear Mode
The parameter specified for • Instruction input
the StartPosition input vari-
able to a motion control
instruction is out of range.
The parameter specified for • Instruction input
the MasterStartDistance
input variable to a motion
control instruction is out of
range.
It was not possible to cre- • For the MC_MoveCir-
ate a circular path for the
specified radius when the
radius method was speci-
fied for the MC_MoveCircu-
lar2D (Circular 2D
Interpolation) instruction.
For the MC_MoveCircu- • For the MC_MoveCir-
lar2D (Circular 2D Interpo-
lation) instruction, the
radius of the circle
exceeded the maximum
value for the border point or
center specification
method.
The parameter specified for • Instruction input
the CircAxes input variable
to a motion control instruc-
tion is out of range.
• The axes that were
• The same axis was
Assumed cause
Maj Prt
parameter exceeded
the valid range of the
input variable.
a Rotary Mode axis is
not within the ring set-
ting range.
the instruction input
parameter exceeded
the range of 40-bit
data when it is con-
verted to pulses.
axis, the target posi-
tion with the travel dis-
tance added
exceeded signed 40-
bit data when the
absolute value is con-
verted to pulses.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
cular2D (Circular 2D
Interpolation) instruc-
tion, it was not possi-
ble to create a circular
path for the specified
radius when the radius
method was specified
for circular interpola-
tion.
cular2D (Circular 2D
Interpolation) instruc-
tion, the radius of the
circle exceeded 40-bit
data when converted
to pulses for the bor-
der point or center
specification method.
parameter exceeded
the valid range of the
input variable.
specified in CircAxes
are not included in the
composition axes in
the Axes Group Set-
tings.
specified for both axes
of CircAxes.
3 Error Tables
Level
Refer-
ence
Min Obs Info
S W502
S W502
S W502
S W502
S W502
S W502
S W502
3-51
3