Omron NX701-17 Series Troubleshooting Manual page 300

3 Error Tables
Event code Event name
04D0 0000 hex Hardware
error
14B00000 hex Linearity cor-
rection data
error
14B10000 hex Linearity cor-
rection data
read error
14B20000 hex System set-
ting error
14B30000 hex Bank data
error
24810000 hex Ethernet
communica-
tion parame-
ter error
74900000 hex Multiple con-
trol signal
input error
74910000 hex EXE input
error
74920000 hex SYNC input
error
74930000 hex TIMING input
error
74940000 hex RESET input
error
74950000 hex ZERO input
error
74960000 hex ZEROCLR
input error
3-222
Meaning Assumed cause
Some abnormality • Hardware damage
occurred on the dis-
placement sensor
hardware.
The linearity correc- • Calibration ROM damage
tion data of the dis-
placement sensor
is damaged.
Reading of the dis- • Calibration ROM not inserted
placement sensor
• Calibration ROM damage
linearity correction
data was not exe-
cuted correctly.
The system set- • The displacement sensor
tings saved to the power was turned OFF during
displacement sen- saving/loading of system set-
sor are corrupt. tings.
The bank data • The displacement sensor
saved to the dis- power was turned OFF during
placement sensor saving/loading of bank data.
is corrupt.
An invalid IP • Invalid IP address setting
address is set for
the displacement
sensor.
Multiple control sig- • Multiple control signals turned
nals turned ON in ON in the same cycle.
the same cycle.
EXE input process- • EXE input turned ON in the
ing was not exe- FUN mode.
cuted correctly.
• EXE input turned ON with
READY output OFF.
SYNC input pro- • SYNC input turned ON in the
cessing was not FUN mode.
executed correctly.
TIMING input pro- • TIMINGx input turned ON in the
cessing was not FUN mode.
executed correctly.
• TIMINGx input turned ON or
OFF while RESETx input was
ON.
• TIMINGx input turned ON in a
non-measurement state.
• TIMINGx input turned ON
before the "delay time + sam-
pling time" elapsed.
RESET input pro- • RESETx input turned ON in the
cessing was not FUN mode.
executed correctly.
ZERO input pro- • ZEROx input turned ON in the
cessing was not FUN mode.
executed correctly.
• ZEROx input turned ON in a
non-measurement state.
• ZEROx input turned ON for a
task whose status is OFF.
ZEROCLR input • ZEROCLRx input turned ON in
processing was not the FUN mode.
executed correctly.
Level
Maj Prt Min Obs Info
S
S
S
S
S
S
S
S
S
S
S
S
S
NJ/NX-series Troubleshooting Manual (W503)
Reference
Z332
Z332
Z332
Z332
Z332
Z332
Z332
Z332
Z332
Z332
Z332
Z332
Z332