Omron NX701-17 Series Troubleshooting Manual page 306

Machine automation controller nj/nx-series
Hide thumbs Also See for NX701-17 Series:
Table of Contents

Advertisement

3 Error Tables
Event code
Event name
64900000 hex
Results Infor-
mation, ID
System Error
1
64910000 hex
Results Infor-
mation, ID
System Error
2
64920000 hex
Results Infor-
mation, ID
System Error
3
64930000 hex
Results Infor-
mation, ID
Tag Status
64940000 hex
Results Infor-
mation, Error
Correction
CJ-series High-speed Counter Units
The section provides tables of the errors (events) that can occur in the following Units.
CJ1W-CT021
The manual names are given below for the catalog numbers given in the Reference column of the
event table.
Cat. No.
W492
Event code
Event name
68010000 hex
Unit Error
3-228
Meaning
Assumed cause
ID system error 1
• System error 1 occurred.
occurred.
ID system error 2
• System error 2 occurred.
occurred.
ID system error 3
• System error 3 occurred.
occurred.
One of the following
• The number of writes was
occurred.
exceeded for a Number of
Writes Control command.
• The number of
• An overflow or underflow
writes was
occurred for a Calculation Write
exceeded for a
command.
Number of Writes
Control com-
• The data did not verify for a
mand.
Data Check command.
• An overflow or
• An error occurred in the data for
underflow
a Read with Error Correction
occurred for a
command.
Calculation Write
• An error occurred when writing
command.
for a Copy command.
• The data did not
verify for a Data
Check command.
• An error occurred
in the data for a
Read with Error
Correction com-
mand.
• An error occurred
when writing for a
Copy command.
A Write with Error
• There is ambient noise where
Correction com-
the ID Tag is used.
mand performed a
• ID Tag error.
1-bit error correc-
tion.
CJ-series High-speed Counter Units Operation Manual for NJ-series CPU Unit
Meaning
Assumed cause
An error occurred in
• There is an error in the Special
Unit Setup.
the High-speed
• An overflow or underflow error
Counter Unit.
occurred.
• An illegal preset value was used.
• A CPU Unit monitor error or bus
error occurred.
Level
Maj
Prt
Min
Obs Info
S
S
S
S
S
Manual name
Level
Maj
Prt
Min
Obs Info
S
NJ/NX-series Troubleshooting Manual (W503)
Reference
Z317
Z317
Z317
Z317
Z317
Reference
W492

Advertisement

Table of Contents
loading

Table of Contents