Omron NX701-17 Series Troubleshooting Manual page 193

Event code Event name
14E40000 hex Invalid SD
Memory Card
66000000 hex Send Trans-
action Queue
Overrun
66010000 hex Reception
Transaction
Queue Over-
run
66020000 hex Too Long
SECS Mes-
sage
95420000 hex GEM Service
Started
95430000 hex Shutdown
Completed
95440000 hex GEM Setting
Data Changed
95450000 hex Valid SD
Memory Card
GEM Instructions
The lower four digits of the following event codes indicate the instruction error codes. For descriptions
of an error code, refer to the description of the corresponding event code. For example, if the error code
of the instruction is 16#0400, refer to the description of the event with event code 54010400 hex.
The manual names are given below for the catalog numbers given in the Reference column of the
event table.
Cat. No.
W502
W528
Event code Event name
54010400 hex Input Value Out
of Range
NJ/NX-series Troubleshooting Manual (W503)
Meaning
An SD Memory • An SD Memory Card is not
Card is not inserted.
inserted or an SD
• The SD Memory Card type is
Memory Card that
not correct.
cannot be written is
• The format of the SD Mem-
inserted.
ory Card is not correct.
• The SD Memory Card is write
protected.
The send transac-
• The capacity to process the
tion exceeded the send transaction is insuffi-
capacity for tempo- cient.
rary storage.
The reception • The capacity to process the
transaction reception transaction is
exceeded the insufficient.
capacity for tempo-
rary storage.
The SECS mes- • The SECS message to be
sage to be sent to sent to the host exceeds the
the host exceeds maximum length.
the maximum
length.
The GEM Service • The GEM Service started
started normally. normally.
The shutdown pro- • The shutdown processing
cessing was com- was completed normally.
pleted normally.
The setting data of • The setting data of the GEM
the GEM Service Service from the SECS/GEM
was changed. Configurator was changed.
An SD Memory • An SD Memory Card that can
Card that can be be written is inserted.
written is inserted.
NJ/NX-series Instructions Reference Manual
NJ-series SECS/GEM CPU Units User's Manual
Meaning
An input parameter for • An input parameter for
an instruction
exceeded the valid
range for an input vari-
able. Or, division by an
integer of 0 occurred in
division or remainder
calculations.
Assumed cause
Maj
Manual name
Assumed cause
Maj
an instruction exceeded
the valid range for an
input variable. Or, divi-
sion by an integer of 0
occurred in division or
remainder calculations.
3 Error Tables
Level
Reference
Prt Min Obs Info
S W528
S W528
S W528
S W528
S W528
S W528
S W528
S W528
Level
Refer-
ence
Prt Min Obs Info
S W502
3
3-115