Omron NX701-17 Series Troubleshooting Manual page 119

Event code Event name
5401542B hex Buffer Mode
Selection Out of
Range
5401542C hex Coordinate System
Selection Out of
Range
5401542D hex Circular Interpola-
tion Mode Selec-
tion Out of Range
5401542E hex Direction Selec-
tion Out of Range
5401542F hex Path Selection Out
of Range
54015430 hex Position Type
Selection Out of
Range
54015431 hex Travel Mode
Selection Out of
Range
54015432 hex Transition Mode
Selection Out of
Range
54015433 hex Continue Method
Selection Out of
Range
54015434 hex Combine Mode
Selection Out of
Range
54015435 hex Synchronization
Start Condition
Selection Out of
Range
54015436 hex Master and Slave
Defined as Same
Axis
54015437 hex Master and Auxil-
iary Defined as
Same Axis
NJ/NX-series Troubleshooting Manual (W503)
Meaning
The parameter specified for • Instruction input
the BufferMode input vari-
able to a motion control
instruction is out of range.
The parameter specified for • Instruction input
the CoordSystem input
variable to a motion control
instruction is out of range.
The parameter specified for • Instruction input
the CircMode input variable
to a motion control instruc-
tion is out of range.
The parameter specified for • Instruction input
the Direction input variable
to a motion control instruc-
tion is out of range.
The parameter specified for • Instruction input
the PathChoice input vari-
able to a motion control
instruction is out of range.
The parameter specified for • Instruction input
the ReferenceType input
variable to a motion control
instruction is out of range.
The parameter specified for • Instruction input
the MoveMode input vari-
able to a motion control
instruction is out of range.
The parameter specified for • Instruction input
the TransitionMode input
variable to a motion control
instruction is out of range.
• _mcAborting or _mc-
The value of the reserved • The value of the
input variable Continuous
to a motion control instruc-
tion changed.
The parameter specified for • Instruction input
the CombineMode input
variable to a motion control
instruction is out of range.
The parameter specified for • Instruction input
the LinkOption input vari-
able to a motion control
instruction is out of range.
The same axis is specified • The parameter is the
for the Master and Slave
input variables to a motion
control instruction.
The same axis is specified • The parameter is the
for the Master and Auxiliary
input variables to a motion
control instruction.
Assumed cause
Maj Prt
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
Buffered was specified
for BufferMode and
_mcTMCornerSuper-
imposed was specified
for TransitionMode.
reserved input vari-
able Continuous
changed.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
same for the Master
and Slave input vari-
ables to the instruc-
tion.
same for the Master
and Auxiliary input
variables to the
instruction.
3 Error Tables
Level
Refer-
ence
Min Obs Info
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502
3-41
3