Omron NX701-17 Series Troubleshooting Manual page 258

3 Error Tables
 Safety I/O Units
Event code Event name
05200000 hex System Error
05210000 hex Internal Cir-
cuit Error at
Safety Input
05220000 hex Internal Cir-
cuit Error at
Test Output
05230000 hex Internal Cir-
cuit Error at
Safety Out-
put
35210000 hex Safety Pro-
cess Data
Communica-
tions Not
Established -
Incorrect Unit
Parameter
Error
35230000 hex Safety Pro-
cess Data
Communica-
tions Not
Established,
Incorrect
FSoE Slave
Address
Error
35240000 hex Safety Pro-
cess Data
Communica-
tions Not
Established,
Incorrect
Frame Error
65200000 hex I/O Power
Supply Volt-
age Error
65210000 hex Output
Power Inter-
rupt Circuit
Error
65220000 hex External Test
Signal Fail-
ure at Safety
Input
3-180
Meaning Assumed cause
A hardware error • Hardware has failed.
was detected
• A memory error occurred due to
during self-diagno-
a transient cause, such as a
sis of the hardware.
software error or excessive
noise.
A fault was • The internal circuit for the
detected in the safety input terminal is faulty.
internal circuit for
• A memory error or signal error
the safety input ter-
occurred due to a transient
minal.
cause, such as a software error
or excessive noise.
A fault was • The internal circuit for the test
detected in the output terminal is faulty.
internal circuit for
• A memory error or signal error
the test output ter-
occurred due to a transient
minal.
cause, such as a software error
or excessive noise.
A fault was • The internal circuit for the
detected in the safety output terminal is faulty.
internal circuit for
• A memory error or signal error
the safety output
occurred due to a transient
terminal.
cause, such as a software error
or excessive noise.
Safety process data • The model or safety I/O termi-
communications nal settings are not correct.
was not estab-
lished with the
Safety CPU Unit.
Safety process data • The setting of the FSoE slave
communications address in the safety process
was not estab- data communications settings
lished with the is different from the setting in
Safety CPU Unit the Unit.
because of an
incorrect FSoE
slave address.
Safety process data • An incorrect frame was
communications received in safety process data
was not estab- communications. There is
lished with the excessive noise.
Safety CPU Unit
because an incor-
rect frame was
received.
An incorrect I/O • The input power or output
power supply volt- power is not supplied correctly.
age was detected.
An error was • The wiring is not correct or
detected by the out- there is a fault in the hardware.
put power interrup-
tion test.
An error was • The positive power supply wire
detected in test is in contact with the input sig-
pulse evaluation of nal line.
the safety input ter-
• The input signal lines are
minals.
shorted.
• The external device is faulty.
Level
Maj Prt Min Obs Info
S
S
S
S
S
S
S
S
S
S
NJ/NX-series Troubleshooting Manual (W503)
Reference
Z930
Z930
Z930
Z930
Z930
Z930
Z930
Z930
Z930
Z930